Solid State SATA DOM Flashdisks
Accessories

Install an MLC or SLC mSATA flashdisk module onto any of our Aries or Helixsingle board computers for rugged, lightweight, solid-state mass storage. The flashdisk module works just like a SATA disk drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 32GB to 64GB. The flashdisk mounts on a SATA disk-on-module connector and is held in place with two spacers and screws (included). It operates over -40ºC to +85ºC.

SATADOM flashdisk features:

✓SATA compatible interface
✓Single-level cell (SLC) flash modules for faster transfer speeds, lower power consumption, and higher cell endurance
✓Multi-level cell (MLC) flash modules for lower cost and higher storage density
✓Burst read/write of 300MB/s
✓Sustained read performance of up to 165MB/s (SLC), 155MB/s (MLC)
✓Sustained write performance of up to 150MB/s (SLC), 80MB/s (MLC)
✓Static wear-leveling scheme with dynamic block allocation increases life and optimizes performance
✓Built-in hardware ECC enables up to 16/24 bit correction per 1K bytes
✓Flash bad-block management
✓Self-Monitoring, Analysis and Reporting Technology (SMART)
✓Power failure management
✓ATA secure erase
✓TRIM enabled for improved performance
✓Supports boot function for Windows Embedded Standard 7, Windows ✓Embedded CE, and Linux
✓Low power consumption:
✓MLC typical 475mA when active and 135mA in sleep mode
✓SLC typical 330mA when active and 95mA in sleep mode
✓Dimensions: 40.0 x 30.0 x 9.0mm
✓-40 ºC to +85ºC operation
✓RoHS compliant

Solid State mSATA Flashdisks
Accessories

Install a MLC or SLC mSATA flashdisk module onto any of our Atlas or Hercules III single board computers for rugged, lightweight, solid-state mass storage. The flashdisk module works just like a SATA disk drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 8GB to 64GB. The flashdisk mounts on a mSATA connector and is held in place with two spacers and screws (included). It operates over -40ºC to +85ºC.

mSATA flashdisk features:

✓SATA compatible interface
✓Single-level cell (SLC) flash modules for faster transfer speeds, lower power consumption, and higher cell endurance
✓Multi-level cell (MLC) flash modules for lower cost and higher storage density
✓Burst read/write of 300MB/s
Sustained read performance of up to 165MB/s (SLC), 155MB/s (MLC)
✓Sustained write performance of up to 150MB/s (SLC), 80MB/s (MLC)
✓Static wear-leveling scheme with dynamic block allocation increases life and optimizes performance
✓Built-in hardware ECC enables up to 16/24 bit correction per 1K bytes
✓Flash bad-block management
✓Self-Monitoring, Analysis and Reporting Technology (SMART)
✓Power failure management
✓ATA secure erase
✓TRIM enabled for improved performance
✓Supports boot function for Windows Embedded Standard 7, Windows Embedded CE, and Linux
✓Low power consumption: MLC typical 475mA when active and 135mA in sleep mode, SLC typical 330mA when active and 95mA in sleep mode
✓Dimensions: 50.8 x 29.85 x 6.0mm
✓-40ºC to +85ºC operation
✓RoHS compliant

Solid State USB Flashdisks
Accessories

Install a USB flashdisk module onto any of our Magellan or Aurora single board computers for rugged, lightweight, solid-state mass storage. The flashdisk module works just like a USB disk drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 1GB to 8GB. The flashdisk mounts on a USB connector and is held in place with a spacer and screw (included). It operates over -40ºC to +85ºC.

USB flashdisk features:

✓USB 2.0 compatible interface
✓Single-level cell (SLC) flash for faster transfer speeds, lower power consumption, and higher cell endurance
✓Sustained read performance of 30MB/s
✓Sustained write performance of 20MB/s
✓Implements dynamic wear-leveling algorithms to substantially increase longevity
✓BCH (6/12 bit) Error Detection Code/Error Correction Code (EDC/ECC0)
✓Intrinsic data integrity after power loss
✓Wear leveling algorithm provides more reliable data storage over time
✓Supports boot function for Windows Embedded Standard, Windows Embedded CE, and Linux
✓Low power consumption, typical 110mA when active and 0.45mA in sleep mode
✓Dimensions: 36.6 x 26.5 x 7.5mm
✓-40ºC to +85ºC operation
✓RoHS compliant
✓An accessory cable, C-FDU-01, is available that connects the USB flashdisk to any USB port. This simplifies programming the flashdisk, or downloading data from it, by providing a direct connection between the flashdisk and a host PC.

Solid State IDE Flashdisks
Accessories

Install an IDE flashdisk module onto many of our single board computers for rugged, lightweight, solid-state mass storage. The flashdisk module works just like an IDE drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 128MB to 4GB. The flashdisk mounts on the IDE connector and is held in place with a spacer and screws (included). It includes a master/slave jumper and operates over -40ºC to +85ºC.

Diamond’s IDE flashdisks are single-level cell (SLC) technology for faster transfer speeds, lower power consumption, and higher cell endurance.